Or you can also use the command below for the same. If data does not appear, take the GPS module near the window and try again. Write below command and all the GPS data will start pouring in as shown in Fig. Now load the gps device with the command below, also shown in Fig. Update and install the GPS libraries using below-given commands, also shown in Fig. Most of the times, it becomes /dev/ttyUSB0 but in case we connect it with the GPIO pins, it becomes /dev/ttyAMA0. After inserting the USB cable look in the /dev/ttyUSB* directory to see which device gets recognised. 4: GPS dataįor simplicity, here we are using the USB cable (refer Fig. The module can either be connected with the USB cable or with just four wires connected directly to the GPIO of Raspberry Pi as shown in the table. For GPS module to work outdoors, you may have to find a clear sky to receive data. There are a variety of GPS modules available in the market but the one with a built-in patch antenna on top (POT) gives the advantage of data reception even indoors. But getting it to work, then pulling out your chosen GPS-related data in python and performing some predefined tasks with the GPS data is something very different and interesting. Since Raspberry Pi is a complete computer in itself with a stable operating system therefore connecting a GPS device to it is just like connecting it to any other computer. A global positioning system (GPS) module is a device used to determine its location on earth in terms of latitude and longitude.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |